AMI Analyzer Manual
Installation and Operation
11
Communication program:
Figure 2. User interface initial screen
Load the program into your laptop computer by putting the CD into its CD or DBVD drive, and following
instructions in the usual way. Make sure the analyzer is turned on and plugged into the computer using the
USB cable before running the program.
The program will come up, and once you click the “Port” button (next to the OPEN COMM button at the
top) will show a screen as above. Select the appropriate port, click “Open Com” and the program will
automatically select the appropriate baud rate and determine the kind of analyzer present. It will fill in the
relevant boxes and grey out the irrelevant ones.
The ports available will be shown. Depending on your particular computer, the port may be anything. If
there are more than one available, you may have to try them all until you get the one that works.
Note that if the analyzer loses power, you will have to restart the AMI program as the USB chip will have to
restart. This is why you have to turn the analyzer on before you run the program.
