38
B. Test run
Check the height limit switch, the hose and fitting connection, if everything is no
problem then do test run. The lift must be tested and checked carefully before in use.
VI. OPERATION INSTRUCTIONS
To lift vehicle
1. Keep clean of site near the lift, and down the lift to the lowest position.
2. Drive vehicle on the platforms and pull the brake.
3. Turn on the power and push the button “
Up”
, raise the lift to the working position.
Note:
make sure the vehicle is steady when the lift is rising
4. Push the button
“Lock”
, lock the lift in the safety device. Make sure the safety
device is locked in the same height.
To lower vehicle
1. Be sure clear of around and under the lift, only leaving operator in lift area.
2. Push the button “
Down”,
the lift is lowered continually and stopped at the height
600mm from ground. Keep feet clear off lift, push button “
DOWN”
while push the
Lowering Alarm Button(PASS)
at the side of control cabinet, the lift is lowered to
ground with alarm tone;
3. Drive away the vehicle when the lift is lowered to the lowest position.
4. Turn off the power.
Fig.
40
The wire of photo cell device
This wire must be removed
during normal working.
Summary of Contents for DX-12A
