30
VI. OPERATION INSTRUCTIONS
Please read the safety tips carefully before operating the lift
To lift vehicle
1.
Keep clean of site near the lift;
2.
Position lift arms to the lowest position;
3.
To shortest lift arms;
4.
Open lift arms;
5.
Position vehicle between columns;
6.
Move arms to the vehicle’s lifting point;
Note:
The four lift arms must at the same time contact the vehicle’s lifting point
where manufacturers recommended
7.
Turn on the power switch (QS1), press the
UP
button until the lift pads contact
underside of vehicle totally. Recheck to make sure vehicle is secure;
8.
Continue to raise the lift slowly to the desired working height, ensuring the balance
of vehicle;
9.
Press the
DOWN
button, lower lift onto the safety position. The vehicle is ready to
repair.
To lower vehicle
1.
Be sure clear of around and under the lift, only leaving operator in lift area;
2.
Press the button of
UP
to raise the vehicle slightly, and then release the safety device,
press the button
DOWN
to lower lift.
3.
Open the arms and position them to the shortest length;
4.
Drive away the vehicle.
5.
Turn off the power.
VII.MAINTENANCE SCHEDULE
Monthly:
1.
Re-torque the anchor bolts to 117 Nm;
2.
Check all connectors, bolts and pins to insure proper mounting;
3.
Lubricate cable with lubricant;
4.
Make a visual inspection of all hydraulic hoses/lines for possible wear or leakage;
5.
Check Safety device and make sure proper condition;
6.
Lubricate all rollers and pins with 90wt. Gear oil or equivalent;
Note: All anchor bolts should take full torque. If any of the bolts does not function for
any reason, DO NOT use the lift until the bolt has been replaced.
Summary of Contents for A240
