AMG Giro turntable
Installation and operating instructions
Dear music-lover, we very much appreciate your choice of the AMG turntable.
Installation:
After you open the cardboard box, please take off the first foam cover. Underneath you will
find the power supply, the pick up arm 9W2 (if you ordered one), the record center support,
the record clamp and the belt as well as a couple of gloves. All the screw drivers you need are
in the tone arm box. Take it all out and put it aside.
Take the next foam cover and underneath you will find the platter put it out carefully aside to
avoid any scratch and damaging the surface.
In the next foam cover you will see the turntable. Place it on your prepared table with a gran-
ite plate or any other solid surface you feel comfortable with.
Now you can bring the turntable in the right angle by adjusting the spikes in the two holes on
the upper side of the chassis with the screwdriver no. 3.
Sling the drive belt around the platter pulley underneath the platter and hold it on the edge
with one finger. Place the platter over the bearing that the motor pulley is located within the
belt. Now put the belt in the groove on the pulley by using both hands. To make sure it is in
the groove, turn the platter 1 or 2 times.
Put on the little plastic ring, with the diagonal upside, over the spindle to heighten your LP.
Speed-Adjusting:
The speed is already set correct by the factory. If it`s necessary to correct the speed for any
reason proceed as described.
Touch the key of the speed you like to modify by at least five seconds. Now you have entered
the programmable mode and the key will illuminate red and green. With the two keys you can
speed up (up to 45) or slow down (up to 33) the platter. Every touch changes the speed only a
little bit so that it might be necessary to touch it a few more times. After setting the speed
touch the key of the selected speed again for at least five seconds and the processor is back in
the normal operating mode.
Tone arm:
For adjusting the pickup arm or installing a cartridge, please check in the tone arm manual.
To turn off your turntable, while it is not in use it is highly recommended to switch off your
power supply or disconnect it from the main plug. For your own safety, you should do a regu-
larly checkup of the power supply. If the isolation is damaged, please contact a specialist right
away.
Enjoy your music
Your Julian Lorenzi with the team of AMG