Use the three provided mounting screws to secure the TG-PEM
board onto the bracket.
5. Connect the TG-PEM to TG-7 or TG-7FS
•
Make sure there are no AC or DC power sources
connected to the TG-7 or TG-7FS. Connect power and
ground from the TG-
PEM terminal labeled “TELGUARD
POWER” to the terminal block on the TG
-7 or TG-7FS
labeled DC and GND.
Do not overtighten.
•
Connect ribbon cable (provided) from the connector on
TG-
PEM labeled “TO HOST” to the 3x2 6
-pin header on
the TG-7 series board as shown. The dark color edge of
the ribbon cable should be oriented away from the
antenna of the TG-7 or TG-7FS.
6. Power Up and Configure
•
Connect power and ground from the panel
auxiliary output to the terminal labeled “PANEL
POWER” on the TG
-PEM to provide power to the
TG-PEM and TG-7 or TG-7FS.
•
Complete the activation of the TG-7 or TG-7FS as
outlined in the TG-7 series manual.
•
If the TG-PEM was preconfigured, it should now
be ready; otherwise, visit www.telguard.com to
configure the TG-PEM.
•
When the TG-PEM is configured and ready, LED
D2 will be either solid amber (in power supply
only mode) or solid green (in power supply and
zone extender mode).
7. Connect Zone Inputs
(if using)
•
Temporarily disconnect the power while you
connect any monitoring sensors to the zone
inputs.
•
For supervised zones, use a standard 2.2k
Ω
EOL
resistor (not included).
•
Reconnect power, allow the TG-7 or TG-7FS to
initialize, and check for proper operation.
Optional: Second TG-PEM Installation
See full Installation Manual for mounting and wiring
instructions.
REFERENCE:
LED
D1
LED
D2
STATUS
DETAILS
Off
Green
Ready, no
activity
TG-PEM is ready
Off
Off
Shut down
Power to TG-PEM is below
minimum
Any
Amber
flash
Communicator
activating
TG is being activated
Red
Green
Reportable
event
At least one enabled input is
tripped or event(s) captured
and waiting to be reported
Red
flash
Green
Event
reporting
Event(s) reporting or waiting
for response
Off
Red
flash
Bootloader
error
Device failure, contact
Technical Support
Off
Amber
Power supply
only or
Not ready
Power supply mode,
TG-PEM waiting for
configuration, or
Communicator not enabled
TO HOST TO TG-PEM
D1 D2
Reset
TELGUARD
POW ER
POW ER
PASS THRU
PANEL
POW ER
DC GND
ZONE INPUTS
1 C 2 3 C 4 5 C 6 7 C 8
G
N
D
D
C
G
N
D
D
C
```
TG-7FS
LTE
3x2 6-pin header
Dark edge on right
LED1
LED2
LED3
LED4
LED5
LED6
LED7
LED8
DC STC2 STC1 TRIP BATT AC
56051801
– Rev A
Note: At power-up, both LEDs will be on for 3 seconds then off for 3 seconds.