User Manual
© 2022 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com
9
2.
Data Interface Cable
a. Overview
i.
The Next Gen PCS Data Interface Cable
consists of a USB connection on one end, and
a RJ-11 connection on the opposite end.
ii.
The USB connection plugs into an available
USB port on your PC. The RJ-11 connection
plugs into the RJ-11
“OUT” Jack (labeled “Data
Por
t”) on the Next Gen PCS Filter, which is the
jack closest to the LCD Event Monitor and RST
button.
b. Instructions for Data Retrieval
i.
Disconnect any protected Modem/Fax lines connected to the
“IN” and “Out”
RJ-11 modular jacks on the Next Gen PCS Filter. Ethernet connections (RJ-45)
may remain in place.
(Skip this step for (XG-PCS-L630 / XG-PCS-630).
ii. Connect the Next Gen PCS Data Interface Cable into the USB port on your PC.
iii. Connect the Next Gen PCS Data
Interface Cable into the RJ-11
“OUT” Jack (labeled “Data Port”)
on the Next Gen PCS Filter. It is
the jack closest to the LCD Event
Monitor and RST button.
For (XG-PCS-L630 / XG-PCS-
630): Connect the Data
Interface Cable into the RJ-11
jack labeled
“Data Port” next to
the LCD on the face of the unit.
iv. Open Next Gen PCS Diagnostic Software.
v. When you are finished, be sure to re-connect the Modem/Fax lines to the “IN” and
“Out” RJ-11 modular jacks on theNext Gen PCS Filter.
