Ametek DDMC, Instruction Manual

Page: 37 / 48

DDMC Analog Input Process Meter / Controller
Instruction Manual
37
Advanced Features Menu
To simplify the setup process, functions not needed
for most applications are located in the Advanced
Features menu.
Press and hold the Menu button for three seconds to
access the advanced features of the meter.
Advanced Features Menu &
Display Messages
The following table shows the functions and
messages of the Advanced Features menu in the
order they appear in the menu.
Advanced Features Menu & Display Messages
Display Parameter Action/Setting
filtEr
Filter Set noise filter value
bypASs
Bypass
Set filter bypass value
Round
Round
Set the rounding value for
display variables
seriAl
Serial Set serial communication
parameters
SlaV Id
Slave ID
Set slave ID or meter
address
baud
Baud rate
Select baud rate
Tr dLY
Transmit delay
Set transmit delay for serial
communication
Parity
Parity
Select parity
Even, Odd, or None with 1
or 2 stop bits
t-byt
Time byte Set byte-to-byte timeout
SelEct
Select
Enter the Select menu
(function, cutoff, out)
Functn
Input signal
conditioning
Select linear, square root,
programmable exponent,
or round horizontal tank
function
Linear
Linear
Set meter for linear
function and select number
of linearization points
Pv 1
PV1
Select PV1 number of
linearization points
Pv 2
PV2 Select PV2 number of
linearization points
Advanced Features Menu & Display Messages
Display Parameter Action/Setting
No PtS
Number of
points
Set PV1 for 2 to 32-point
linearization
Set PV2 for 2 to 8-point
linearization
Square
Square root
Set meter for square root
extraction
Prog E
Programmable
exponent
Set meter for
programmable exponent
and enter exponent value
rht
Round
horizontal tank
Set meter for round
horizontal tank volume
calculation
Inch
Dimension
Calculate volume in
gallons
cnm
Dimension
Calculate volume in liters
dianmr
Diameter
Enter the tank’s diameter
in inches
Length
Length Enter the tank’s length in
inches
CutofF
Cutoff
Set low-flow cutoff
AoutPr
Analog output
programming
Program analog output
parameters
Source
Source
Select source for the
4-20 mA output
O-rang
Overrange
Program mA output for
display overrange
u-rang
Underrange Program mA output for
display underrange
break
Break
Set input break condition
operation
nmAx
Maximum
Program maximum mA
output allowed
nmin
Minimum Program minimum mA
output allowed
Calib
Calibrate
Calibrate 4-20 mA output
(internal reference source
used for scaling the output)
4 nmA
4 mA output
Enter mA output value
read by milliamp meter
with at least 0.001 mA
resolution
20 nmA
20 mA output
Enter mA output value
read by milliamp meter
with at least 0.001 mA
resolution
user
User I/O
Assign function keys and
digital I/O
F1
F1 function key Assign F1 function key
F2
F2 function key
Assign F2 function key
F3
F3 function key Assign F3 function key
F4
F4 function
Assign F4 function (digital
input)
dI I
Digital input 1 Assign digital input 1 – 8, if
expansion modules are
connected