Ametek Chandler Engineering 3260, Instruction Manual

Page: 9 / 26

SECTION 1 – INSTALLATION 1-1
Section 1 – Installation
Unpacking the Instrument
The following components are included with the complete 3260 system
:
•
Mixer base
•
Viton 1 Liter cup adapter
•
Mixer drive shaft
•
Mixer cup (1-Liter) with lid
Accessories supplied with instrument (check against accessory list inside the packing).
NOTE: Verify all parts listed on packing slip have been shipped with
instrument. If parts are missing, contact Chandler Engineering.
Utilities Required
Model 3260-110V: 120 VAC
Model 3260-220V: 230 VAC
Tools/Equipment Required
None required
Setting up the Instrument
1. Install the rubber adapter over the adapter shaft.
2. Install the cup into the rubber adapter.
3. Connect the power cord from the mixer base to an appropriately rated power source in
accordance with local wiring codes.
CAUTION: Wear hearing protective when using the mixer.
CAUTION: Check your power supply against your Model 3260 system
power rating. Damage can occur if incorrect line voltage is
applied.