Page 4
For technical questions, please call 1-888-866-5797.
Item 64014
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
15. People with pacemakers should
consult their physician before use.
Electromagnetic fields in close
proximity to heart pacemaker could
cause pacemaker interference
or pacemaker failure.
16. Do not test voltage on circuits
higher than 600 volts.
17. Do not test current on circuits
higher than 10 amps.
18. Dress properly. Protective,
electrically nonconductive
clothes and nonskid footwear are
recommended when working.
19. Wear ANSI-approved safety
goggles during use.
20. Only use accessories intended
for use with this meter.
21. Avoid damaging meter. Use only
as specified in this manual.
22. Prior to testing resistance, diodes,
or continuity; disconnect all power
to the circuit and discharge all
high-voltage capacitors.
23. Performance of this meter may vary
depending on battery condition.
24. Use the proper settings, terminals,
techniques, and range for the
tests performed. Start with the
range stated in the instructions.
25. Do not apply voltage to the Test
Leads when the Multimeter is in
the Ohms testing setting. Damage
can occur to the Meter.
26. Do not switch between testing
modes with the multimeter
connected to a circuit.
27. Do not use the meter at a setting
marked as blank on the scale.
28. Have the multimeter calibrated by
a qualified technician every year
to maintain accurate results.
29. Do not disassemble multimeter;
take it to a qualified technician
when service or repair is required.
Incorrect reassembly may result
in a risk of electric shock or fire.
30. The warnings, cautions, and
instructions discussed in this
instruction manual cannot cover all
possible conditions and situations
that may occur. It must be understood
by the operator that common sense
and caution are factors which cannot
be built into this product, but must
be supplied by the operator.
SaVE tHESE inStructiOnS.
