AmeriWater Heatsan 00HS208, Operation & Maintenance Manual

Page: 12 / 80

11
98-0156 Rev G
Note: The maximum number of dialysis machines that the unit can
supply depends on the volume of hot water required per machine and
the rate at which they draw water. So long as the total volume of water
required does not exceed the maximum available for draw off and the
maximum draw rate does not exceed the pump performance. See
pump limits above.
Environment
Parameter Limits
Room storage and operating
temperature range
(41-104°F)
Relative humidity 30 to 80%
Maximum altitude 6562 ft (2000m)
Transport and storage
temperature
23°F to 203°F (Dry unit)
RFI/EMI radiation
The EMC environment must be within the
limits to which the unit has been tested, see
Section 3.10 below.
Care must be taken not to place near the unit
any source of RFI/EMI, which is liable to cause
electromagnetic disturbance. If the unit is
affected by such disturbance, the source must
be suppressed or moved.
Classification and Standards Applied
Class 1 equipment Electrical
Insulation Category II
Pollution Degree II
Type IIB applied part
EMC
UL 61010-1, Issue 07/12/2004, Ed:2,
Rev:10/28/2008 Standard for Electrical
Equipment for Measurement, Control,
and Laboratory Use Part 1: General
Requirements and CSA C22.2# 61010-1,
Issue: 07/12/2004, Ed:2 (R2009) Safety
Requirements for Electrical Equipment
for Measurement, Control, and
Laboratory Use Part 1: General
Requirements, with general instruction
No. 1:2008/10/28 – R2009.