2
3. SET UP
1.
Remove the hoses and pump from the CIP tank (pump, hoses and fittings
are shipped inside the tank from the manufacturer).
2.
Rinse the CIP tank and hoses with clean water to remove any debris or
contamination after un-packing or after the CIP system has been in
storage.
3.
Install two of the long hoses into the upper ports on the tank by screwing
the 1” pipe thread adapter that is on the end of the hose into the pre-
mounted bulkhead fitting. Use two to three wraps of Teflon tape to aid
installation and to seal the pipe threads.
Summary of Contents for CLEAN IN PLACE CIP2
Page 2: ......
