A
B
C
D
A
B
B
B
B
C
C
D
D
1
E
F
G
H
2
E
E
H
F
G
3
4
1 piece sink body
1 piece drainer
Place the sink (A) upside down on the floor.
Use the hex wrench (D) to remove 8 pcs hex screws (C) from
four corner support of sink (A).
Insert each leg (B) into each corner support of sink (A).
Use the hex wrench (D) to tighten the hex set screws (C) into
the corner support. Each corner support requires two hex screws.
Separate the whole drainer (E).
Then reassemble the drainer on the sink as shown above.
Put sink (A) on the hanging bar (F).
Rotate the leg feet pads to compensate for differences in
floor surface.
According to the height of the baffle plate of the sink (A), drill holes in
the wall.
Then put each plastic tubbing (H) into each hole.
Insert each screw (G) through the hanging bar (F) into the
plastic tubbing (H).
1 piece hanging bar
2 pieces screws
for hanging bar
2 pieces plastic tubbing
for hanging bar
4 pieces leg w/feet 8 pieces hex screws 1 piece hex wrench
ITEM # SSUSK1816 STAINLESS STEEL UTILITY SINK
