Step 10: Install the Screws that will Allow the
Doors to Slide in Accordion
a) Slide the door #1 and #2 so we can see both sliding holes.
b) Use the proper screwdriver bit (provided with the unit) to tighten the special screws.
c) Tighten the screws until they don’t go down anymore (they are not supposed to press against the other sliding door)
d) Repeat the last step for the door #2 and #3 and also the door #3 and #4
Step 11: Setting Travel Stops
The gate upper track assembly comes with three flange nut/ set screws installed
in the top track to stop the panels from moving beyond points that would allow for
openings that compromise the safety function is provides.
The position for the third flange nut/set screw will vary depending on the gate
opening direction but they are easy to install and adjust with a standard hex key.
On the bottom track one of the set screws prevents the gate from coming out of the
end of the track.
The second set screw on the bottom track must be adjusted to stop the trailing
edge of panel 1 from traveling past the interior wall of the car on the pocket side.
If this is not set properly panel 1 can travel to far in the closed direction creating
a gap between the trailing edge of the gate and the wall on the pocket side of the
elevator.
WARNING
Failure to properly set the mechanical travel stops could cause
serious injury or death.
Scan to watch!
Panel Stop Setting Video
(3 minutes)
Left Hand Opening place nuts in these positions
Right Hand Opening place nuts in these positions
35
