Step 24: Wire Upper Landing Call Station and Interlock
Install
1. Unravel the wiring from the Upper Gate and thread the wiring
through the tubing, run the wire and tubing to the Tower Controller.
2. Connect the Call Station (and Interlock if applicable) to the Tower
Control using the appropriate Quick Connects (3-PIN for the
Call Station and 4-PIN for the Upper Interlock.)
3. Remove the interlock i2 jumper cable on the Tower Controller.
Refer to the previous page.
DANGER
!
It is
VERY IMPORTANT
to remove the jumper
cable labeled
INTERLOCK i2
before proceeding
with the installation.
!
TIP:
If you need to shim the upper landing gate, which could
cause a little bump, we suggest adding a stainless steel plate
as a threshold ramp.
TIP:
3- PIN quick connect is for the Call Station and the 4-PIN quick
connect is for the interlock.
29
