3-6
E. dUAL BRIdGE
the Dual Bridge (a) is designed to connect two units into a bin-
ocular configuration.
Dual Bridge also allows the binocular configuration to be attached
to the headmount or helmet mount.
to mount the units with Dual Bridge perform the following:
1. align the unit and the Dual Bridge.
2. push the clamps (B) on the front of Bridge.
3. Slide the unit rearwards until the alignment boss aligns with
the alignment groove (C) on the Bridge. push until the unit locks
into the Bridge.
4. repeat for second unit.
to detach the unit push the clamps on the front of Dual Bridge
and slide the unit forwards.
Dual Bridge allows using the NVM14 with 3x Binocular Lens as
a pair of dual tube binocular.
Figure 3-5
Mounting of the dual Bridge
H. MOUNTING IR-450 TO THE ATN NVM-14
Ir-450 may be mounted on the monocular through the picatinny
adapter.
1. Mount picatinny adapter(a) onto one of the rails on the
monocular. tighten two fixing screws(B) of the adapter.
2. loosen the Ir-450 fixing screw (C).
A
B
C
Summary of Contents for ATN NVM14
