INSTALLATION INSTRUCTIONS
1
1A
• Apply a bead of putty to bottom edge of
ESCUTCHEON with PUTTY PLATE (
1
).
Make certain the SEAL (
9
) is properly seated in
recess of faucet body. Insert SUPPLY HOSES (
2
),
SPRAY HOSE (
7
) and SHANK (
3
) through hole of
ESCUTCHEON with PUTTY PLATE (
1
) and
mounting surface. Follow mounting instructions
below to secure faucet to mounting surface.
• Insert HOSES (
2
) through RUBBER WASHER (
4
),
BRASS WASHER (
5
), and threaded LOCKNUT (
6
).
• Assemble RUBBER WASHER (
4
), BRASS
WASHER (
5
), and threaded LOCKNUT (
6
) onto
SHANK (
3
) from underside of sink or mounting
surface. Hand tighten LOCKNUT (
6
).
• Use a screwdriver to tighten SCREWS (
8
) on
LOCKNUT (
6
). Work your way around LOCKNUT
(
6
), tightening the screws slightly each time until
all are snug to ensure even pressure.
INSTALL WITH ESCUTCHEON
INSTALL WITHOUT ESCUTCHEON
A
A
Turn off hot and cold water
supplies before beginning.
SINK OR
MOUNTING
SURFACE
7
PUTTY
2
3
4
5
8
6
7
FAUCET BASE
1
9
4
5
8
7
6
9
10
3
2
SINK OR
MOUNTING
SURFACE
7
• Discard ESCUTCHEON with PUTTY PLATE (
1
)
Make certain the SEAL (
9
) is properly seated in
recess of RING BASE (
10
). Insert supply
HOSES (
2
), SPRAY HOSE (
7
) and SHANK (
3
)
through mounting hole and seat RING BASE (
10
)
onto sink or mounting surface. Do not use putty.
• Insert HOSES (
2
) through RUBBER WASHER (
4
),
BRASS WASHER (
5
), and threaded LOCKNUT (
6
).
• Assemble RUBBER WASHER (
4
), BRASS
WASHER (
5
), and threaded LOCKNUT (
6
) onto
SHANK (
3
) from underside of sink or mounting
surface. Hand tighten LOCKNUT (
6
).
• Use a screwdriver to tighten SCREWS (
8
) on
LOCKNUT (
6
). Work your way around LOCKNUT
(
6
), tightening the screws slightly each time until
all are snug to ensure even pressure.
