2
MAKE WATER SUPPLY CONNECTIONS
3
CONNECT SPRAY HOSE AND INSTALL WEIGHTS
With PULL-OUT SPRAY
(1)
seated in FAUCET
(2)
,
install WEIGHTS
(3)
onto HOSE
(4)
using SCREW
(5)
.
Locate the WEIGHT
(3)
two feet (2') from the
underside of the sink deck.Tighten SCREW
(5)
firmly.
Make sure SEAL WASHER
(7)
is installed in COUPLING
NUT
(6)
. Connect threaded end of HOSE
(4)
to SPRAY HOSE
COUPLING NUT
(6)
from fitting. Use wrench to tighten.
1
2
COLD
HOT
Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES
(1, 2)
directly
to wall supplies. Connection on fitting
supplies are 3/8" compression. Connect
left supply (Marked with a Red Stripe) to Hot
and right supply (Marked with Blue Stripe) to
Cold wall supply. Use adjustable wrench to
tighten connections. Do not over tighten.
Faucet supplies are 21" long from faucet base.
Note: If additional supply length is
required, installer must purchase
additional parts separately.
Important: If SUPPLY HOSES (1, 2) are
too long, loop as illustrated to avoid kinking.
4
6
7
2
CHECK CONNECTIONS FOR LEAKS.
Move HANDLE
(1)
into the "off" position.
Turn on water supplies and check connections
for leaks
.
CHECK CONNECTIONS
FOR LEAKS
4
1
1
M 9 6 5 2 4 5 R E V. 1. 2
5
3
24"
