M 9 6 5 4 7 3 R ev. 1. 1
Place the SPRAY HOLDER
(1)
into the appropriate mounting hole.
Assemble the SPRAY HOLDER WING NUT
(2)
onto the shank of
SPRAY HOLDER
(1)
from below and hand tighten.
Do not use putty.
For installation less spray, cap off SPRAY HOSE
CONNECTION
(3)
with PIPE CAP
(4)
.
3
INSTALL SPRAY HOLDER
1
5
4
2
TEST INSTALLED FAUCET
Move HANDLE into "off" position and remove
AERATOR
(1)
.
Turn on water supplies and check connections for leaks
.
Operate HANDLE
(2)
up and down, left and right to flush
water lines thoroughly.
For faucet with spray, direct SPRAY HEAD
(3)
into sink and
activate SPRAY
(3)
. Check hose connections for leaks.
Move HANDLE
(2)
to "off" position and replace
AERATOR
(1)
.
6
3
4
CONNECT HOSE SPRAY
Feed SPRAY HOSE
(5)
through SPRAY
HOLDER
(1)
and attach COUPLING NUT
(6)
of HOSE
(5)
to SPRAY HOSE CONNECTION
(3)
on valve body. Tighten COUPLING NUT
(6)
firmly.
2
SPRAY HOSE
CONNECTION
MAKE WATER SUPPLY CONNECTIONS
Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES
(1, 2)
directly
to wall supplies. Connection on fitting
supplies are 3/8" compression. Connect
left supply to Hot
(Marked with a Red Line)
and right supply to Cold wall supply. Use
adjustable wrench to tighten connections.
Do not over tighten.
Faucet supplies are 21" long from faucet base.
Note: If additional supply length is
required, installer must purchase
additional parts separately.
Important: If SUPPLY HOSES (1, 2) are
too long, loop as illustrated to avoid kinking.
CHECK CONNECTIONS
FOR LEAKS
3
1
2
1
2
COLD
HOT
