M 9 6 8 5 8 2
2
1
3
SERVICE
5
Loosen and remove LEVER HANDLE
(1).
Loosen
HANDLE SCREW
(2)
with 2.5mm Hex Wrench and
then pull HANDLE BASE
(3)
off.
Unscrew ESCUTCHEON CAP
(4)
. Unscrew the
CARTRIDGE NUT
(5)
and remove METAL WASHER
(8)
.
Remove CARTRIDGE
(6)
. Clean inlets of
CARTRIDGE
(6)
and MANIFOLD
(7)
.
Reassemble CARTRIDGE
(6)
. Replace CARTRIDGE
NUT
(5)
, CAP
(4),
METAL WASHER
(8)
and
HANDLE assembly, check flow.
SERVICE
Clogged CARTRIDGE outlets or inlets may cause reduced
flow.
To clean, first turn off water supply then:
If SPOUT (1) leaks at swivel point the O-RINGS (2) need
to be replaced. To remove SPOUT (1)
:
Turn faucet to off position. Loosen the SPOUT SET SCREW
(3)
with a 3mm Hex wrench.
Rotate the SPOUT
(1)
side to side while pulling upward to
remove SPOUT
(1)
from faucet body.
Replace the defective parts and grease O-RINGS
(2)
. Push
SPOUT
(1)
back into position. Tighten SET SCREW
(3)
.
Check that SPOUT
(1)
rotates freely and does not leak
at the swivel point.
4
6
REMOVE
INSTALL
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
2
3
1
8
4
5
6
7
CLEAN
METAL
WASHER
3mm HEX
WRENCH
