3
4
INSTALLING BACK AND SIDE WALLS
INSTALLING THE CORNER PANEL
3a.
Wipe back side of all panels and walls with a damp cloth to remove any dust or debris and allow
to fully dry.
3b.
Apply adhesive in a zig-zag pattern on the wall within marked lines, keeping bead thickness to 1/8
"
(3mm)
or less. (Ref. Illustration A)
NOTE:
Applying beads of adhesive thicker than 1/8
"
(3mm) may make it difficult to spread behind the
panel once it is up and installed creating a ripple effect on the panel.
3c.
Move Rear Panel onto the wall keeping a space of approximately 1/8
"
(3mm) off of the surface of the
shower base and keeping panel between the marked line previously drawn. Press panel firmly over entire
surface to ensure firm contact of panel to adhesive on wall. (Ref. Illustration B)
NOTE:
It may be necessary to brace or support the panel against the wall until the panel stays securely
in place.
Place a cloth under the supports to prevent marring of the walls surface.
3d.
Install side panels in the same manner using the same adhesive pattern. Wipe off any excessive adhesive
with mineral spirits.
4a.
Place Corner Panel into rear corner of shower and check for proper fit to shower walls.
NOTE:
Make sure corner panel is aligned right side up so that flat shelving surface is facing upward.
Ensure Corner Panel completely overlaps Rear and Side Panels by at least 1/4
"
(6mm).
4b.
Apply adhesive to rear corner (Ref. Illustration A) top to bottom, side to side and on back of the Corner
Panel (Ref. Illustration B) and place into rear corner of shower (Ref. Illustration C). Press firmly to hold
in place.
NOTE:
It may be necessary to brace or support the corner panel in position until the adhesive dries.
Use cloth under any support to prevent any marring of the walls finished surface.
4c.
Wipe the panel down with a damp rag while continuing to apply pressure to the panel to ensure it makes
complete contact.
NOTE:
Wipe any excess adhesive from the panel with a damp rag or mineral spirits.
NOTE:
INSTALL ONLY ONE WALL AT A TIME AND REMOVE FILM FROM WALLS PRIOR TO INSTALLATION.
B
A
Support
Braces
B
A
APPLY SEALANT
ALONG THE BACK
CORNER PANEL
C
