FLEXIBLE
INLET HOSES
HOT
COLD
RECESS
34440 REV. 1.4
1
2
TEST INSTALLED FAUCET
3
SWING SPOUT ASSEMBLY
FITTING INSTALLATION
For Model 7190.132 Only
Connect hot or cold water supply lines to shank using
sealant, appropriate connectors, and coupling nuts.
For Model 7100.2XX Only
SHANK
SUPPLY
NUT
RECESS
SERVICE
4
Turn off hot and cold water
supplies before beginning.
CAUTION
5
Assemble the SPOUT
(3)
and tighten the
SPOUT NUT
(4)
until snug on VALVE BODY.
1
2
3
4
Remove AERATOR.
With handle in OFF position, turn on water supplies
and check all connections for leaks.
Operate both handles to flush water lines thoroughly.
Checkspout mounting and hose connections for leaks.
Turn handles into OFF position and replace AERATOR.
To change direction of handle rotation,
proceed as follows:
Turn valve to OFF position.
Remove INSERT and HANDLE SCREW.
Slip HANDLE with ADAPTER off.
Remove SPRING CLIP
(1)
.
Lift STOP WASHER
(2)
, turn 90
°
and replace.
Replace SPRING CLIP
(1)
.
Replace ADAPTER, HANDLE, SCREW, and INSERT.
AERATOR may accumulate dirt causing distorted and reduced
water flow. Remove AERATOR and rinse clean.
If spout drips, operate handles several times from OFF to ON
position. Do not force - handles turn only 90
°
.
Plastic SCREEN
(3)
in CARTRIDGE
(4)
may accumulate
dirt causing reduced water flow. To clean, first turn
off hot and cold water supplies, then:
Remove INSERT and HANDLE SCREW.
Slip HANDLE with ADAPTER off.
Unscrew CARTRIDGE
(4)
with wrench.
Thoroughly rinse plastic SCREEN
(3)
at
base of CARTRIDGE
(4)
.
Replace CARTRIDGE
(4)
until flange is
tight against valve body.
Turn valves OFF.
Replace ADAPTER, HANDLE, SCREW,
and INSERT.
90
°
1
2
3
4
Place RUBBER RING
(4)
in recess of fitting.
Insert inlet hoses
(on model 7190.132 only)
and
THREADED SHANK through hole of sink making
certain RUBBER RING
(4)
is properly seated in the
recess of the fitting base.
Assemble GASKET
(3)
, BRASS WASHER
(2)
, and
LOCKNUT
(1)
onto the THREADED SHANK from
underside of sink deck.
Tighten the LOCKNUT
(1)
securely.
Connect the hot water supply to the left inlet hose
and the cold water supply to the right inlet hose
using appropriate connectors.
Remove LOCKNUT
(1)
, BRASS WASHER
(2)
, and
GASKET
(3)
from fitting.
1
2
3
4
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
CARE INSTRUCTIONS:
MODEL
7190.132
MODEL
7100. 2XX
