- 3 -
M965557 Rev. 1.2
TEST INSTALLED FAUCET
• Unthread SPRAY HOSE
(3)
from SPRAY
(2)
.
• Turn on water supplies and check connections for leaks
.
• Hold HOSE END
(3)
in sink and operate HANDLE
(1)
on and off,
hot and cold to flush water lines thoroughly. Replace SPRAY
(2).
• Pull SPRAY
(2)
out and check hose and supply connections
for leaks. Check that SPRAY HOSE
(3)
and WEIGHT
(4)
slide
up and down freely and do not interfear with supplies or waste
outlet plumbing. With faucet on turn SPRAY TOP
(5)
to spray
and aerator fuctions.
• Check all drain connections for leaks.
• Move HANDLE
(1)
to "off" position.
• Move HANDLE
(1)
into "off" position.
1
2
5
3
3
4
HOT & COLD SUPPLIES
5
• Loosen and remove LEVER HANDLE
(1).
Loosen HANDLE SCREW
(2)
with 2.5mm Hex Wrench and then pull HANDLE BASE
(3)
off.
• Unthread ESCUTCHEON CAP
(4)
. Unthread the CARTRIDGE NUT
(5)
.
• Remove CARTRIDGE
(6)
. Clean inlets of CARTRIDGE
(6)
and MANIFOLD
(7)
.
• Reassemble CARTRIDGE
(6)
. Replace CARTRIDGE NUT
(5)
, CAP
(4)
and HANDLE assembly, check flow.
•
Clogged CARTRIDGE outlets or inlets may cause reduced flow.
To clean, first turn off water supply then:
•
If SPOUT (11) leaks at swivel point the O-RINGS (12) need
to be replaced. To remove SPOUT (11)
:
• Disconnect SPRAY HOSE
(8)
from CONNECTING NUT
(9)
.
• Loosen the SPOUT SET SCREW
(10)
with a 3mm Hex wrench.
• Rotate the SPOUT
(11)
side to side while pulling upward to remove
SPOUT
(11)
from faucet body. Remove SPRAY HOSE
(8)
.
• Replace the defective parts and grease O-RINGS
(12)
. Replace SPRAY
HOSE
(8)
. Push SPOUT
(11)
back into position. Tighten SET SCREW
(10)
.
Reconnect SPRAY HOSE
(8)
to CONNECTING NUT
(9)
.
• Check that SPOUT
(11)
rotates freely and does not leak at the swivel point.
9
8
11
3mm
HEX WRENCH
12
1
2
3
4
5
6
CLEAN
7
REMOVE
INSTALL
10
5
SERVICE
