- 4 -
M965521 Rev. 1.6 (1/15)
INSTALL RISER SUPPLY PIPING
• Install ESCUTCHEON SEALS
(1)
into groove in escutcheon base.
• Slide BRASS WASHERS
(2)
onto RISER PIPES
(3).
• Install RISER SUPPLY PIPES
(3)
into mounting holes in floor.
From underside of floor install BRASS WASHERS
(2)
and
LOCK NUTS
(4)
onto RISER SUPPLY PIPES
(3)
. Do not tighten
LOCK NUTS
(4)
fully.
NOTE:
RISER SUPPLY PIPES
(3)
are 1/2" (13mm) NPT female connection.
INSTALL BATH FILLER
• Install two SEAL WASHERS
(1)
into
COUPLINGS
(2)
if not already installed.
• Align FLOOR SUPPLIES
(3)
with inlets of
COUPLINGS
(2)
. Thread COUPLINGS
(2)
to FLOOR SUPPLIES
(3)
. Do not fully tighten.
• When aligment of BATH FILLER and FLOOR
SUPPLIES are complete, fully tighten MOUNTING
NUTS
(4)
below floor and COUPLINGS
(2)
on BATH FILLER
(5)
.
• Tighten ESCUTCHEON SET SCREWS
(6)
with Hex Wrench supplied to secure
ESCUTCHEON
(7)
.
• Connect Hot and Cold supplies to RISER
SUPPLY PIPES
(3)
. Connections are
1/2" (13mm) NPT female.
1
2
3
5
HOT
COLD
4
2
4
3
6"
(152mm)
1/2" (13mm) NPT female
6
7
1
2
3
GROOVE
2
2
4
4
1/2" (13mm) NPT FEMALE
SUPPLY CONNECTION
3
4
