Adjustable Wrench
Channel Lock Pliers
Regular Screwdriver
Recommended Tools & Materials
Phillips Screwdriver
Pipe Wrench
Putty Knife
Drill
Saber Saw
Basin Wrench
Plumbers' Putty or Caulking
Tubing Cutter
Tape
Measure
Hacksaw
NOTE: For installation of models using concealed or exposed arms, follow instruction provided by arms manufacturer.
Level
S
A
VE FOR FUTURE USE
730427-100 Rev. E
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
Product names listed herein are
trademarks of AS America, Inc.
© AS America, Inc. 2015
NOTE:
Pictures may not exactly define contour of china and components.
WALL HUNG SINK
INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed
properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be
sure your installation conforms to local codes.
!
OBSERVE LOCAL PLUMBING AND BUILDING CODES
3
1
2
4
Provide suitable reinforcement behind
finished wall for lavatory hanger mounting
screws.
*
Determine horizontal center line
location of support from the table listed in
Step 2. (Make sure support bottom
extends to lavatory back wall bottom.)
NOTE: If replacing an existing sink be
certain to shut off water supply before
removing old sink.
Hanger
Location
C/L of 2x8
Support
Finished
Floor
*
Determine the
desired rim height
(for example 32")
then select from the
Table at right the
height of the hanger
mounting bolts
centerline
EXAMPLE:
For Lucerne:
32"-1"= 31"
For Missouri:
32"+1"= 33"
Drill pilot holes in positioning screw
slots of hanger. (Note: Some models
are supplied with anchor screws, or
steel hangers for lavatory installations.
Other models are not provided with
mounting hardware which can be
purchased at local hardware outlets.
Lavatories with bottom anchor screw
holes should be secured with anchor
screws in addition to hangers.
Part #
Model
TABLE
Distance "A"
0124
0321
0355/0356
0372/0373
4867/4869
0436
9024
Comrade
Declyn
Lucerne
Penlyn
Regalyn
Missouri
Decorum
- 2-1/2" (64mm)
- 2-3/4" (70mm)
- 1" (25mm)
- 1/8" (3mm)
+ 2-3/4" (70mm)
+ 1" (25mm)
- 3-11/16" (93mm)
HOLES FOR
ANCHOR SCREWS
IN BACK DRAPERY
RIM
HEIGHT
*
SUPPLIES
AS REQUIRED
WASTE
FINISHED FLOOR
HANGER
C/L OF HANGER ANCHORING SLOTS
MOUNTING
SCREW
HOLES (4)
POSITIONING
SCREW
SLOTS (2)
A
Position hanger according to Step 2,
making sure its center is aligned
with the waste hole centerline.
Mark the hanger screw locations
through its mounting holes.
