CARTRIDGE INLETS
MANIFOLD
1
2
3
4
M968882 Rev. 1.7 (11/17)
10
• With HANDLE
(1)
in OFF position, turn on WATER
SUPPLIES
(2)
and check all connections for leaks.
• Ensure that AERATOR
(3)
is tightened completely.
• Operate HANDLE
(1)
to allow water flow.
ADJUST HOT LIMIT STOP
TEST INSTALLED FITTING
9
3
2
5
2
“P” TRAP
WASTE
OUTLET
4
1
• Operate POP-UP KNOB
(4)
and fill lavatory with water.
Check that DRAIN STOPPER
(5)
makes a good seal
and retains water in Sink. If DRAIN STOPPER
(5)
does not seal properly, please refer to Troubleshooting
section in these instructions.
• Release POP-UP KNOB
(4)
down and check all drain
connections and
“P” trap
for leaks. Tighten
if necessary.
CHECK DRAIN CONNECTIONS
HOT LIMIT SAFETY STOP ADJUSTMENT
By restricting handle rotation and limiting the amount of hot water allowed to mix with the cold, the HOT LIMIT SAFETY STOP
reduces risk of accidental scalding. To set the maximum hot water temperature of your faucets, all you need to do is adjust
the setting on the HOT LIMIT SAFETY STOP.
• Use a flat blade screwdriver or your fingers to pull up and rotate red HOT LIMIT SAFETY STOP
(1)
. Follow Step “A” or “B” to
adjust min./max. discharge temperature. “1” being the hottest to “8” the coldest temperature setting. Factory set at “1”.
- 4 -
11
SERVICE
PRY RED RING UPWARD
AND ROTATE
COUNTER-CLOCKWISE
"A"
ADJUSTMENT WHEN WATER IS TOO HOT
PRY RED RING UPWARD
AND ROTATE CLOCKWISE
"B"
ADJUSTMENT WHEN
WATER IS TOO COLD
"RED RING"- HOT LIMIT SAFETY STOP
"B"
"A"
TEMPERATURE
SETTING NUMBERS
If Faucet Drips Proceed As Follows
• Turn VALVE in OFF position.
• If faucet drips, operate handle several times from “off” to “on”.
Do not apply excessive force.
• Clogged CARTRIDGE INLETS may cause reduced flow in “full on” hot
or cold. To clean inlets, first turn off water supply, then:
• Remove HANDLE
(1)
, CAP
(2)
and CARTRIDGE
(3)
.
• Clean CARTRIDGE INLETS and MANIFOLD.
• Reassemble CARTRIDGE
(3)
, alternately tightening SCREWS
(4)
.
Replace CAP
(2)
and HANDLE
(1)
. Check flow.
