6
7
TEST INSTALLED FITTING
8
ADJUST HOT LIMIT STOP
By restricting handle rotation and limiting the amount of
hot water allowed to mix with the cold, the HOT LIMIT
SAFETY STOP reduces risk of accidental scalding. To set
the maximum hot water temperature of your faucet,
all you need to do is adjust the setting on the HOT LIMIT
SAFETY STOP
(1)
.
Use a flat blade screwdriver or your fingers to pull up and
rotate red HOT LIMIT SAFETY STOP
(1)
. Follow
Step "A"
or
"B"
to adjust min./max. discharge temperature.
"0"
being
the hottest to
"7"
the coldest temperature setting. Factory
set at
"0"
.
With HANDLE
(1)
in OFF position, turn on
WATER SUPPLIES
(2)
and check all
connections for leaks.
Remove AERATOR
(3)
.
Operate HANDLE
(1)
up and down, in COLD and HOT
positions, to flush water lines thoroughly.
Direct SPRAY HEAD
(4)
into sink. Open faucet and
activate spray. Check SPRAY HOSE
(5)
connections
for leaks.
Replace AERATOR
(3)
.
9
PRY RED RING UPWARD
AND ROTATE COUNTER-
CLOCKWISE ONE CLICK
PRY RED RING UPWARD
AND ROTATE CLOCKWISE
"A"
ADJUSTMENT WHEN
WATER IS TOO HOT
"A"
"A"
"B"
"B"
ADJUSTMENT WHEN
WATER IS TOO COLD
"B"
"RED RING"- HOT
LIMIT SAFETY STOP
TEMPERATURE
SETTING NUMBERS
0
1
2
3
4
5
6
1
M66241 REV.1.2
3
2
1
5
4
Clogged CARTRIDGE
(1)
inlets or outlets may cause reduced
flow in "full on," hot or cold. To clean ports, first turn off Hot
and Cold water supplies, then:
Remove BUTTON
(2)
, loosen HANDLE SCREW
(3)
and pull
HANDLE
(4)
off.
Remove ESCUTCHEON CAP
(5)
.
Lift CARTRIDGE
(1)
off MANIFOLD
(7)
, remove SEALS
(8)
.
Clean ports, SEALS
(8)
.
Replace ESCUTCHEON CAP
(5)
, HANDLE
(4)
, and tighten
HANDLE SCREW
(3)
. Replace PLUG BUTTON
(2)
.
Remove three MOUNTING SCREWS
(6)
.
Insert SEALS
(8)
back into CARTRIDGE
(1)
. Place CARTRIDGE
(1)
onto MANIFOLD
(7)
and alternately tighten the three
MOUNTING SCREWS
(6)
.
If hand spray water
flow is restricted, lift
DIVERTER
(10)
using
long-nose pliers. Clean
and replace.
If faucet drips, operate HANDLE
(4)
several times from
"off" to "on." Do not apply excessive force.
AERATOR
(9)
may accumulate dirt causing distorted and reduced
water flow. Remove, clean, and replace AERATOR
(9).
1
7
2
3
5
6
8
9
4
10
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
CARE INSTRUCTIONS:
