M968644 REV.1.4 (10/16)
2
4
5/16'' MIN.
MOUNTING
SURFACE
FOR FITTING
LESS SPRAY
11
11
10
2
1
3
Push TUBING
(3)
ends into VALVE
(4)
side outlets. Insert VALVES
(4)
into mounting holes from underside of ledge.
Press TEE
(5)
onto SPOUT SHANK
(6)
making certain that the O-RING
(7)
is
properly seated on SHANK
(6)
. Push COUPLING
(8 or 8a)
into TEE
(5)
and
attach to SPOUT SHANK
(6)
and tighten. For 7430.901 use a 10 mm
(3/8") hex key.
Install LOCKNUTS
(1)
and RUBBER WASHERS
(2)
onto valve shanks.
Place RUBBER RING
(10)
into ESCUTCHEON ADAPTERS
(9)
and thread onto
valves until snug against internal stop.
Tighten LOCKNUT
(1)
to secure VALVE
(4)
position with channel locks.
Slide FERRULE
(12)
and COUPLING NUT
(13)
to outlet of VALVE
(4)
and tighten
COUPLING NUT
(13)
firmly.
Connect HOT water supply to inlet of left VALVE and COLD water supply to inlet of
right VALVE using appropriate connector.
VALVE ASSEMBLY
HOT
COLD
12
13
7
6
8
8a
5
13
12
3
4
4
MOUNTING
SURFACE
Threads of VALVE BODY
(4)
should extend at least 5/16 inch above
MOUNTING SURFACE
(11)
. If necessary, adjust LOCKNUT
(1)
.
10
9
9
8
7
4
5
INSTALL HANDLES
1
2
4a
4
5
1
3
LEVER HANDLE
CROSS HANDLE
FLAT BLADE
SCREWDRIVER
Push ADAPTER
(1)
on VALVE STEM
(2)
. Tighten
STEM SCREW
(3)
with a flat blade to secure ADAPTER
(1)
.
(Figure A)
Find correct position of HANDLE ASSEMBLY
(4, 4a)
by adjusting
male teeth on ADAPTER
(1)
to female teeth in HANDLE
(4, 4a)
.
Thread HANDLE ASSEMBLY
(4, 4a)
onto DECK ADAPTER
(5)
until snug against mounting surface.
THREAD ON
TO DECK
ADAPTER
(Figure A)
To change direction of handle rotation,
proceed as follows:
Turn valve to OFF position.
Thread counter-clock wise HANDLE BASE
(1)
to remove
HANDLE ASSEMBLY
(2)
from ESCUTCHEON BASE
(3)
.
Use a flat blade screw driver to remove SPRING CLIP
(4)
.
Lift STOP WASHER
(5)
, turn 90˚ and replace.
Replace SPRING CLIP
(4)
.
Reinstall HANDLE ASSEMBLY
(2)
.
If spout drips, operate handles several times from OFF to ON
position. Do not force - handles turn only 90˚.
SERVICE
90˚
1
5
3
4
2
1
