M968583
1a
INSTALL FAUCET WITHOUT ESCUTCHEON PLATE
(4101.115 with soap dish) (4101.350 less soap dish)
Assemble RUBBER WASHER
(5)
, BRASS WASHER
(6)
and threaded LOCKNUT
(7)
onto SHANK
(4)
from underside
of sink or mounting surface. Hand tighten LOCKNUT
(7)
and check that rotation of HANDLE
(8)
from HOT to COLD
is centered.
Use a screwdriver to tighten SCREWS
(9)
on LOCKNUT
(7)
. Work your way around LOCKNUT
(7)
, tightening the
SCREWS
(9)
slightly each time until all are snug to ensure even pressure.
Insert SEAL WASHER
(1)
into ESCUTCHEON
(2).
Place ESCUTCHEON
(2)
onto sink or mounting surface.
Insert supply
TUBES
(3)
and SHANK
(4)
through ESCUTCHEON
(2)
and mounting surface.
Make sure slot in fitting base aligns with
tab on
ESCUTCHEON
(2). Figure 1.
HOT
COLD
2
MAKE WATER SUPPLY CONNECTIONS
Turn off hot and cold water supplies before beginning.
Push HOSE END
(1)
with compression fitting onto COPPER TUBE
(2)
Make sure
HOSE and COPPER TUBE are fully engaged (approx.1/2" engagement). Use adjustable
wrench to tighten connections. Do not over tighten.
Connect FLEXIBLE SUPPLIES
(3)
directly to wall supplies. Connection on fitting
supplies are 3/8" compression. Connect left supply (Marked with a Red Stripe)
to Hot and right supply to Cold wall supply. Use adjustable wrench to tighten
connections. Do not over tighten.
Faucet supplies are 24-1/2" long from faucet base.
Note:
If additional supply length is required, installer must purchase
those parts separately.
Important:
If SUPPLY HOSES (3) are too long, loop as illustrated to avoid kinking.
Assemble RUBBER WASHER
(5a)
, BRASS WASHER
(6a)
, and threaded LOCKNUT
(7a)
onto SHANK
(11)
from underside
of sink or mounting surface. Hand tighten LOCKNUT
(7a)
. Use a screwdriver to tighten SCREWS
(9a)
on LOCKNUT
(7a)
the same as fitting installation above.
Install SPOUT ASSEMBLY:
Insert SEAL WASHER
(1a)
into ESCUTCHEON
(2a).
Insert SPOUT HOSE
(10)
and SHANK
(11)
through ESCUTCHEON
(2a)
and mounting surface. Make sure slot in spout base aligns with tab on ESCUTCHEON
(2a).
Figure 2.
Install SPRAY HOLDER:
Insert SPRAY HOLDER
(11)
into ESCUTCHEON
(12).
Insert SEAL
(14)
into underside of
ESCUTCHEON
(12)
. From underside of sink or mounting surface thread LOCKNUT
(13)
onto SPRAY HOLDER
(11)
shank and tighten.
ALIGN SLOT
AND TAB
SLOT
RED STRIPE
1/2"
ENGAGEMENT
TAB
2a
1a
11
5a
6a
9a
Figure 1
Figure 2
5
6
7
9
8
ALIGN SLOT
AND TAB
SLOT
TAB
13
2
1
3
2
1
3
4
12
11
14
10
7a
