15
Test run
2. Confirm Feminine wash too.
- 7 -
14
Leakage check
6mm in
diameter
Plastic
expansion tube
Bracket
Wooden screw
remote controller
Bracket
Stop
Posterior
Feminine
100mm
200mm
Bracket
Self-tapping screw
Water supply
angle valve
a. Punch a hole 6mm in diameter on the composite board.
(For plasterboard wall, punch a hole 5mm in diameter.)
b. Knock the plastic expansion tube into the hole lightly with
a hammer.
a. Use the remote controller to flush the toilet several times.
b. Confirm that there is no water leakage at all connections,
and that the flushing wrench operates properly.
c. Secure the bracket firmly with a wooden tapping screw.
The screwing is very difficult at first, becomes easier
gradually, and finally difficult again.
(2) Align the remote controller with the bracket from the
top and press it down to the specified position.
(1) Fully open the switch wrench of the water supply
angle valve and supply water to the toilet.
1.Confirmation of posterior and feminine.
(1) Stick your arm to the sitting sensor.
(2) Press Posterior button.
(3) After the nozzle is extended, put your hand in front
of it to prevent water from spraying outside.
(4) Press Stop button to stop Posterior.
(2) Confirm that no water leakage will happen.
(3) Confirm that the toilet flushes properly.
●
When installed on plasterboard or composite board
wall less than 5mm thick
●
For installation on a composite board wall 5mm or
more thick, use a wooden tapping screw to secure the
bracket onto the wall.
ON
Switch wrench