- 6 -
11
Power supply connection
12
Positioning of the remote controller
(1) Connect the power plug to power socket.
(2) Confirm whether the power is on.
Confirm that the E-bidet's power indicator is on.
(1) Install the bracket in the mounting position using
a method compatible with the wall quality.
(2) Temporarily place the remote controller where you
want to install it. Sit on the toilet seat and press the
Stop button. Confirm that the power indicator on the
back cover of the shower toilet flickers.
(1) Open the back cover of the remote controller and put
in the battery (two AA batteries).
13
Installation of remote controller
●
When installed on concrete wall
6mm
in diameter
33
mm
Plastic
expansion tube
Bracket
Wooden
tapping screw
Alkaline dry
battery
Back cover
When loading the battery, do not connect the
positive and negative terminal reversely.
Do not mix the old battery with the new one.
* Be sure to turn on the power after the E-bidet is installed.
* When the power indicator is not on, press the restart
button to confirm whether the power light is on.
* Do not plug in while sitting on the toilet seat. This may
render the nozzle (Posterior, Feminine) unable to spray
water. When the nozzle fails to spray water, plug in again
without touching the toilet.
* Note that pressing the [Posterior] or [Feminine] button
may cause water to squirt out.
* When installing the remote controller, reserve the space
for you to remove the remote controller from above the
bracket.
a. Punch a hole 6mm (0.24 in) in diameter and approx.
33mm (1.3 in) deep.
b. Knock the plastic expansion tube into the hole lightly
with a hammer.
c. Secure the bracket firmly with a wooden
tapping screw.