Pub. No. 11-AC14D1-6
PAGE 7
INSTALLER'S GUIDE
8. Supply registers and return grilles
open and unobstructed ................................................... [
]
9. Return air filter installed .................................................. [
]
10. AccuLink™ control is accurate.
Check against a reliable thermometer.
Adjust per instructions with AccuLink™ control ............. [
]
11. Is correct speed tap being used?
(Indoor blower motor) ...................................................... [
]
12. Operate complete system in each mode
to insure safe operation. ................................................. [
]
1. Refrigerant Line, Leak checked ...................................... [
]
2. Suction Lines and Fittings properly insulated ................ [
]
3. Have all Refrigerant Lines been secured
and isolated properly? .................................................... [
]
4. Have passages through masonry been sealed?
If mortar is used, prevent mortar from coming into
direct contact with copper tubing .................................... [
]
5. Verify tightness of all electrical connects ....................... [
]
6. Observe outdoor fan during on cycle for
clearance and smooth operation .................................... [
]
7. Indoor coil drain line drains freely.
Pour water into drain pan ................................................ [
]
CHECKOUT PROCEDURE
After installation has been completed, it is recommended that the entire system be checked against the following list:
MOUNTING HOLE LOCATION
NOTE: ALL DIMENSIONS ARE IN MM (INCHES).
From Dwg. D152989 Rev. 2
