Atlantis PCI Pentium II ISA Motherboard User’s Guide
38
Standard Setup,
Continued
Primary Master, Primary Slave, Secondary Master, Secondary Slave Select one of these
hard disk drives to configure the hard disk drive named in the option. The
settings for each of these drives are:
Setting
How to Configure
SCSI
You do not have to set any other parameters if you select
SCSI. The SCSI drivers provided by the SCSI drive or
SCSI host adapter manufacturer should allow you to
configure the SCSI drive.
Auto
Select Auto to let AMIBIOS determine the parameters.
Click on OK when AMIBIOS displays the drive
parameters. You can also change these parameters if you
do not think AMIBIOS detected the drive parameters
correctly or if you want to enable an enhanced IDE
feature. You can modify these parameters as follows:
Select LBA/Large Mode. Select On if the drive has a
capacity greater than 540 MB.
Select Block Mode. Select On to allow block mode data
transfers.
Select 32-Bit Mode. Select On to allow 32-bit data
transfers.
Select the PIO Mode. It is best to select Auto to allow
AMIBIOS to determine the PIO mode. If you select a PIO
mode that is not supported by the IDE drive, the drive will
not work properly. If you are absolutely certain that you
know the drive’s PIO mode, select PIO mode 0 - 5, as
appropriate.
ARMD
Select this setting if you are configuring an LS-120, MO
(Magneto-Optical), or Iomega Zip drive. After completing
Standard Setup, go to
CD-ROM
Select CDROM if configuring an ATAPI drive. AMIBIOS
displays the drive parameters.
1 – 46
(Standard Old
MFM Drive)
If you are configuring an old MFM drive and you know
the drive type, select the correct drive type between 1 –
46.
USER
(Non-Standard
MFM Drive)
If you are installing an old MFM drive and you do not
know the drive type or the drive parameters do not match
the drive parameters for types 1 – 46, enter the correct
hard disk drive parameters.
Cont’d
