American-Lincoln SR9772 510-015, Instructions For Use Manual

Page: 24 / 91

American-Lincoln 1-23
SR9772
OPERATING INSTRUCTIONS
LOW DETERGENT WARNING LIGHT
26. A Warning light on control panel will illuminate when the detergent tank is low on detergent.
27. NOTE: The camel system will operate automatically and intermittently. The fl oat system in the recovery tank and the system
control logic will automatically control the pumping of the water from the recovery tank into the solution tanks, once operating
conditions are met.
28. If the solution tanks are full, the system will not pump water from the recovery tank to the solution tanks; the system will remain in
standby mode until the solution tank capacity is available.
29. If the recovery tank is low on solution the system will not activate, and will remain in standby mode until enough solution is
available to pump from the recovery tank into the solution tanks. Once the system activates, the camel system will pump the
solution from the recovery tank into the solution tank, until the solution tanks if full or the recovery tank compartment in low.
30. Inspect the scrub path and verifying the scrub performance and solution recovery.
31. Continue scrubbing, monitoring the scrub path for maximum performance.
32. Warning lights on the scrubber control panel for low solution or high recovery will illuminate when the solution level is low or the
recovery tank is full.
33. The recovery tank fl oat ball will also activate when the tank is full. The vacuum air fl ow bypass will activate, discontinuing solution
recovery.
34. Activate the switch at the control panel to raise scrub deck. Press and hold the switch in upward position for 2 seconds and
release, the switch will return automatically to the neutral position. Con fi rm that the scrub deck is in the raised position.
35. Continue moving over the scrub area until the squeegee recovers all of the solution.
36. Activate the switch at the control panel to raise the squeegee and turn off the vacuum system. Press and hold switch in an
upward position for 2 seconds and release, the switch will return automatically to a off position. Con fi rm the squeegee is raised
and the vacuum has stopped.
37. Push the hydraulic control lever foward to off/de-energize position.
38. Move the scrubber to the appropriate location to drain the recovery tank by
fi rst reducing the throttle to low idle, depress clutch,
select range and gear, slowly release clutch and increase throttle.
31. Park the scrubber at the location by depressing the clutch and reducing throttle to low idle, move range and gear levers to
neutral, apply brakes. When fully stopped, apply the parking brake and turn off engine.
40. Lower drain hoses on rear of unit to direct recovered fl uid to appropriate dump location.
41. Remove drain plug.
42. Once the recovery tank is drained, open the clean out doors by loosening knobs and pivoting the “t” bolts.