American-Lincoln
1-45
3366XP
GAS TANK
The gas tank is located under the drivers seat. It may be
filed from the rear of the machine.
HOPPER ADJUSTMENT
The following adjustments are made to the hopper at the
factory. Once adjusted, no further attention should be
required.
1. Install hopper stops loosely.
2. Adjust stops to give 3 5/8 (9.2 cm.) inches clearance
under rear bottom edge of hopper, then secure.
3. Using the adjusting screw, set the hopper square in the
machine with equal clearance between the wheel wells
and the outer edges of the hopper on both sides. Set
the jam nut.
STEERING ADJUSTMENT
1. Loosen the mounting hardware at the steering pivot
bracket.
2. Rotate the rear wheel yoke to a 90° full left turn posi-
tion. Be sure the cylinder is fully extended.
3. Tighten the mounting hardware.
FILL
FUEL
TANK
FUEL
TANK
P4692
FIGURE 34
3.63"
HOPPER SWITCH
HOPPER ADJUSTING SWITCH
LIFT ARM
SWITCH
C0136
FIGURE 35
STEERING
PIVOT
BRACKET
ADJUSTMENT
C0137
FIGURE 36
GENERAL MACHINE MAINTENANCE
