All Double DIN Applications
DASH DISASSEMBLY INSTRUCTIONS
2003-08 Pontiac Vibe/2003-04 Toyota Matrix
1. Starting from the bottom of the Radio trim bezel, carefully pry outward on
the dash trim bezel to unclip the lower edge and sides.
2. Angle the dash trim bezel outward from the bottom and pull the top of the
panel down to unfasten the two upper tabs.
3. Pull the trim bezel forward and disconnect all harnesses attached to the
panel and remove panel.
4. Remove the harness clamp attached at the rear of the left factory radio bracket.
5. Remove the (4) 10mm bolts securing the factory radio to the sub-dash.
6. Pull radio forward, disconnect the wire harness and antenna lead and remove radio.
**Remove all mounting tabs on the Side Brackets not shown above.
Remove all mounting Tabs on ISO Trim Ring
FIG. D
Pontiac
VIBE
Toyota
MATRIX
Attach mounting brackets to radio
components using screws supplied
with kit or radio
See bracket preparation
for your vehicle
Attach trim ring to brackets before
tightening radio mounting brackets
For kit assembly instructions see Figure E on page 5
4
