4
For mounting the unit flush to a wall or other rigid
surface, the ears may be installed on the sides
with the oval holes flush with the bottom of the unit
as in Figure 2. Mount the ears with the #10
flathead screws provided. Mount the
unit to a rigid surface using #10 (5mm) screws.
POWER SOURCE
The internal power supply accepts universal line voltage. Any mains supply from 100 to
240 VAC, 50 to 60 Hz, may be used without modification or adjustment. A universal
power connector is provided on the rear of the unit to facilitate connection to the power
mains.
POWER CONNECTION
The unit is supplied (in the US and UK only) with a three conductor power cord. The
“ground” conductor is directly connected to the chassis.
INPUT / OUTPUT CONNECTIONS
The fiber optic connection is made via a FC/PC connector located at the back of the unit.
Be sure to allow sufficient room for the required minimum bend radius of the fiber cable
used.
Video input and output connections are located on the rear of the unit. A BNC connector
is provided for each channel. The video inputs are connected to an appropriate 75
Ω
baseband video source such as a camera or a video recorder output. The 75
Ω
video
outputs can be looped through typical baseband video inputs of switchers, recorders and
other equipment as required. For proper operation, the outputs must be terminated with
75
Ω
. For optimum performance the video cables should be the shortest length of coax
practical.
Data input and output connections are located on the rear panel terminal block. A mating
plug connector is provided.
The figure below identifies the specific connections for the
Sensornet data connections.
