SPEEDDOME OPTIMA LT INDOOR CAMERA DOME INSTALLATION AND SERVICE GUIDE (8200-0181-01, REV. C)
4 of 14
Power cable requirements—Indoor Dome
The following table shows the maximum cable
distance for several worst-case low line voltages
between various indoor power sources and the
indoor SpeedDome Optima. These distances are
for Sensormatic composite cables, which use 18
AWG
ac power wires.
This table applies to domes produced after October
of 2001; distances are much less for earlier domes.
Twisted Pair Adapter
The ADACTP01BNC Twisted Pair Adapter
(supplied) can be used to transmit video or video
with up-the-coax (UTC) dome control signals over
unshielded twisted pair (UTP) cables, point-to-
point, up to 300m (1000ft).
The adapter mounts directly to the video source or
receiver without additional cabling and uses
Category 2-6 twisted pair wires to transmit the
video and dome control signals. The adapter does
not require power.
One adapter is supplied. If used, another adapter
must be ordered to for the connection at the other
end of the cable. The figure below shows twisted
pair cable connections. See installation guide
8200-0298-01 for details.
Indoor Dome
Worst-Case Meters
AC Power Source
Low Line V
(Feet)
28 VA
117 130
(425)
Transformer
100 80
(250)
5604-0006-01
90 60
(200)
50 VA
117 160
(525)
Transformer
100 100
(325)
5604-0044-01
90 60
(200)
1-position SensorNet
117 160
(525)
RJ1SNUD
100 100
(325)
90 80
(250)
1-position SensorNet
240 160
(525)
RJ1SNUD-1
200 100
(325)
180 80
(250)
117 210
(675)
6-position SensorNet
100 130
(425)
Indoor J-Box
90 80
(250)
RJ6SN
240 210
(675)
200 130
(425)
180 80
(250)
Universal Transformer
117 130
(425)
0300-0914-01
100 100
(325)
90 60
(200)
Universal Transformer
240 160
(525)
0300-0914-03
200 100
(325)
180 80
(250)
Video Switcher/
Controller
Cat 2-6 UTP Cable
Twisted Pair Adapter
(Switcher/Controller End)
American Dynamics
Dome Or
Fixed Camera
Twisted Pair Adapter
(Fixed Camera End)
Twisted Pair Adapter
(Dome End)