Intellex® RMS Installation Note
2
INSTALLING THE HARD DRIVES
The six hard drives packaged with the Intellex RMS must be installed in the unit. The
hard drives are each contained in caddies so they may be easily installed.
1. Remove the drives from the packaging.
2. Unlock the front cover of the RMS unit and open the front cover.
3. Press the latch release on the left side of the drive caddy to release the latch.
IMPORTANT: The latch must be in the open position as in the photo below in
order to install the hard drive.
4. Carefully slide the caddy containing the hard drive into an empty slot in a drive
bay and seat it firmly. You can install any drive into any slot.
Pushing slowly ensures proper connector lineup. If not done with care, the
connectors may be damaged. Do not use the latch to push the hard drive carriage.
5. Once the hard drive is seated firmly in the drive bay, close the latch to finish the
drive’s installation.
6. Repeat this process for the remaining five hard drive caddies.
WARNING: DO NOT POWER UP THE UNIT UNTIL ALL SIX HARD DRIVES ARE
INSTALLED.
