18
REPLACE BURNER TUBE ASSEMBLY (Refer to the
illustration below
)
1. Discontinue power to the dryer.
2. Remove the four (4) hex nuts that hold the burner hood bracket to the burner box.
3. Remove the two (2) hex nuts that hold the burner tube to the burner box.
4. Pull down on the burner tube to remove it.
5. Reassemble new burner tube (
ADC
PN: 141137) in reverse procedure.
IMPORTANT:
Make sure the gap from the ignitor to the top of the burner tube is 1/8” +/- 1/32”
(3.175 mm +/- 0.79248 mm).
TO REPLACE THE IGNITOR PROBE
1. Discontinue power to the dryer.
2. To remove the ignitor probe, remove the two (2) screws that hold them to the burner box.
3. When replacing ignitor probe, remove screws, disconnect high voltage (HV) wire from DSI module and
remove the probe and high voltage (HV) wire from the ignitor.
4. Replace new items in reverse procedure.
IMPORTANT:
DO NOT
wrap the high voltage (HV) wire and flame-probe wires together, improper
operation may result. They may run along side each other.
IMPORTANT:
Make sure the gap from the ignitor to the top of the burner tube is 1/8” +/- 1/32”
(3.175 mm +/- 0.79248 mm).
Summary of Contents for AD-540
Page 64: ...60 ...
Page 65: ...ADC450246 1 09 08 03 0 ...
