113235 - 5
www.amdry.com
39
WARNING:
If the water in the supply line or water solenoid valve freezes, the S.A.F.E. system
will be
INOPERATIVE!!
IMPORTANT:
Appliance is to be connected to the water mains using a new hose set and the old
hose set
should not be
reused.
2. Water Connections:
The water connection is made to the 3/4”-11.5
NH hose adapter of the electric water solenoid
valve, located at the rear upper midsection of the
dryer (refer to the photograph).
The water solenoid valve has a 3/8” M.P.T.
connection supplied with a 3/4”-11.5 NH hose
adapter to provide the minimum 1/2-inch supply
(feed) line. Flexible supply line/coupling
must
be
used in an effort to avoid damaging the electric
water solenoid valve.
NOTE:
The 3/4”-11.5 NH is a standard hose coupling screw thread. It
is
not
to be confused with
3/4” N.P.T. The sealing of an NH connection is made with a washer opposed to the
mating threads of an N.P.T. assembly. The two (2) thread designs
are
not
compatible.
IMPORTANT:
Flexible supply line/coupling
must be
used. Solenoid valve failure due to hard
plumbing connections WILL VOID WARRANTY.
It is recommended
that a
filter or strainer be installed in the water supply line.
Typical water supply:
