background image

American DJ

®

 

6122 S. Eastern Ave.

Los Angeles CA. 90040

www.americandj.com

  Rev. 8/08

User Instructions

American DJ

®

  -  www.americandj.com  - X-Color LED™ Instruction Manual Page 2

  X-Color LED™  

      

                             General Information

Unpacking: 

Thank you for purchasing the X-Color LED™ by Ameri-

can  DJ

®

.  Every  X-Color  LED™  has  been  thoroughly  tested  and  has 

been shipped in perfect operating condition. Carefully check the ship-
ping carton for damage that may have occurred during shipping. If the 

carton appears to be damaged, carefully inspect your fixture for any 

damage and be sure all equipment necessary to operate the unit has 
arrived intact. In the event damage has been found or parts are miss-
ing, please contact our toll free customer support number for further 
instructions. Please do not return this unit to your dealer without con-

tacting customer support first. 

Introduction: 

The X-Color LED™ is a three channel DMX intelligent,  

color changing LED fixture. The X-Color LED™ can operate as a 

stand 

alone

 fixture or in a 

Master/Slave configuration. The X-Color LED™ is 

a sound active fixture, but it can also be controlled via DMX

For best 

results use fog or special effects smoke to enhance the beams projec-
tions. 

Customer  Support:

  American  DJ

®

  provides  a  toll  free  customer 

support line, to provide help and to answer any question should you 
encounter problems during your set up or initial operation. You may 
also visit us on the web at www.americandj.com for any comments or 
suggestions. Service Hours are Monday through Friday 9:00 a.m. to 

5:00 p.m. Pacific Standard Time.

 

Voice:   

(800) 322-6337

 

Fax: 

  

(323) 582-2941

 

E-mail:  

[email protected]

To purchase parts online visit http://parts.americandj.com

Warning! 

To prevent or reduce the risk of electrical shock or fire, do 

not expose this unit to rain or moisture. 

Warning! 

This may cause severe eye damage. Avoid looking directly 

into the light source at all times!

Summary of Contents for X-Color LED











Reviews: