ADJ Products, LLC - www.adj.com - WiFly Wash Bar User Manual Page 15
WiFly Wash Bar WiFly Master-Slave Set Up
This feature will let you link units to run in a master-slave mode.
1. Follow the instructions on pages 9-10 to set the Wireless address.
The addresses on each fixture must be the same.
2. After you have set the WiFly address, follow the instructions on
page 9 to assign your Master unit. After setting your Master unit,
set your desired operating mode.
3. For the “Slave” units, put the unit in Slave mode. See page 9 to
assign the unit as a Slave.
4. Put the antennas in either a up position or down position.
Note: All antennas must be in the same position, they must either be
all up or all down, but never at an angle.
NOTE: If they do not sync up master-slave, switch the Master fix-
tures power switch off then on again.
ADJ Products, LLC - www.adj.com - WiFly Wash Bar User Manual Page 14
WiFly Wash Bar DMX Control
DMX Mode:
Your DMX controller must be connected to a ADJ WiFly
TransCeiver (sold separately). Operating through a DMX controller
gives the user the freedom to create their own programs tailored to
their own individual needs. You are able to communicate up to 400
feet (open line of sight). The WiFly Wash Bar has 3 DMX modes: 3
Channel mode, 4 Channel mode, and a 6 Channel mode, See pages
16-18 for each modes DMX traits.
1. This function will allow you to control each individual fixture’s
traits with a standard DMX 512 controller.
2. To run your fixture in DMX mode press the MODE button until
“Addr” is displayed, and press ENTER. The current address that
is set will be displayed Use the UP or DOWN buttons to select
your desired DMX address, then press ENTER.
3. To select your desired DMX Channel mode press the MODE but-
ton until “Chnd” is displayed, and then press ENTER.
4. Use the UP or DOWN buttons to scroll through the DMX Channel
modes. The Channel modes are listed below:
• To run the 3 Channel Mode, press the UP or DOWN buttons until
“3Ch” is displayed.
• To run the 4 Channel Mode, press the UP or DOWN buttons but-
ton until “4Ch” is displayed.
• To run the 6 Channel Mode, press the UP or DOWN buttons but-
ton until “6Ch” is displayed.
Once you have found your desired Channel mode, press ENTER.
5. Please see pages 16-18 for DMX values and traits.
6. After you have chosen your desired DMX Channel you need to set
the WiFly address. Follow the instructions on pages 9-10 to set
the Wireless address. The address must match the address set
on the WiFly Transceiver.
7. Apply power to the ADJ WiFly Transceiver. The fixture must be set
up to the same address as the fixture first before you apply power
to WiFly TransCeiver.
8. If everything is set up properly and the fixture is receiving a
Wireless signal, Wireless status will be indicated in the LED
screen.
