ADJ Products, LLC - www.adj.com - WiFly Wash Bar User Manual Page 11
WiFly Wash Bar System Menu
the setup is the running mode the fixture will go into when
the DMX signal is lost. You can also set this as the operat-
ing mode you would like the unit to return to when power is
applied.
1. Press the MENU button until “BLND” is displayed, press
ENTER.
2. Either “MASL”, “blnd”, or “LASt” will be displayed. Choose an
operating mode you would like the unit to start up in when power
is applied or the DMX signal is lost.
• “MASL” (Master/Slave) - If the DMX signal is lost or power is
applied, the unit will automatically go into Master Slave mode.
• “blnd” (Blackout) - If the DMX signal is lost or power is applied,
the unit will automatically go into stand by mode.
• “LASt” Last State - If the DMX signal is lost the fixture will stay
in the last DMX set up. If power is applied and this mode is set,
the unit will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
BALA
-
With this function you can adjust the RGB colors
and change the tone of the White Output.
1. Press the MENU button until “
BALA
” is displayed, press
ENTER.
2. Use the UP or DOWN buttons to find the color you wish to
adjust.
3. Once you find the color you want to adjust press ENTER, the
displayed value will begin to flash. Use the UP or DOWN but-
tons to adjust the value. Once you have made your adjustment
press ENTER.
4. Repeat steps 2-3 until satisfied.
ADJ Products, LLC - www.adj.com - WiFly Wash Bar User Manual Page 10
WiFly Wash Bar System Menu
2. “
X
” will now be displayed, “X” representing a number between
0-15. Press the UP or DOWN buttons to find your WiFly address.
3. When you have found your desired WiFly address press ENTER
to confirm and exit.
SHND: SH
1
-
SH16
-
Show modes 1-16 (Factory pro-
grams) or Color mode.
1. Press the MENU button until “
SHND
” is displayed, press
ENTER.
2. “
Sh
X
” will now be displayed, “X” representing a number
between 1-16 or “COLO” will be displayed. Programs 1-16 are
factory programs. “COLO” is a RGB mode, in this mode you are
able to adjust the RGB colors to create your own desired color.
Use the UP or DOWN buttons to find you desired mode then
press ENTER.
3. If you select Show mode, use the UP or DOWN buttons to
find your desired show, then press ENTER. You are now be able
to adjust the fade time (“FXXX”). The fade time can be adjusted
between “F0” (fastest) and “F255” (slowest). After adjusting the
fade time, press ENTER to adjust the wait time (“UXXX”).
4. If you select Color mode, use the UP or DOWN buttons find the
color you would like to adjust. When you find you desired color,
press the ENTER button to select. Then use the UP and DOWN
buttons to adjust the output intensity of the selected color. When
you have found your desired output intensity for your selected
color, press ENTER.
5. When you have finished press ENTER, then press and hold the
MENU button for at least 3 seconds to activate.
BLND
- This mode can be used as a precaution mode, that
in case the DMX signal is lost, the operating mode chosen in
