Torch Light™
Set-Up/Operation Cont.
Repositioning The Flame (Silk Drape):
You may wish to reposition the flame drape to customize the effect.
1. Move the flame drape along the flame attachment bars by sliding
the magnetic ends along the metallic tabs.
2. For best results, do not stretch out the ends of the silk drape as
tight as it can get along the bottom. For a more realistic effect
allow some play between the two ends of the silk drape, move the
magnets slightly away from the side of the casing to achieve a
more realistic flame effect.
©
American DJ Supply
®
- www.americandj.com - Torch Light™ Instruction Manual Page 6
©
American DJ Supply
®
- www.americandj.com - Torch Light™ Instruction Manual Page 5
Torch Light™
Lamp Replacement
Torch Light™
Silk Drape
The silk drape has become creased:
You may iron the flame using a non-drip iron. Do not steam iron.
The silk drape has become frayed:
You may use a sharp pair of scissors to carefully cut the loose silk
strands. Silks become frayed after a period of four weeks. This can be
sooner depending on the environment.
Torch Light™
Warranty Card
The Torch Light™ carries a one year (365 days) limited warranty. We
recommend you fill out the enclosed warranty card to validate your
purchase. All returned service items whether under warranty or not,
must be freight pre-paid and accompany a R.A. Number. If the unit is
under warranty, you must provide a proof of purchase invoice.
Halogen Lamp Warning!
This fixture is fitted with
halogen lamps which are highly susceptible to
damage if improperly handled. Never touch the
lamps with your bare fingers as the oil from your
hands will shorten lamp life. Also, never move the
fixture until the lamps have had ample time to cool.
Remember, lamps are not covered under warranty
conditions.
Torch Light™
Halogen Lamp Warning
Caution:
Always replace with the exact same type lamp and fuse, unless oth-
erwise specified by an authorized American DJ
®
technician. Replace
with anything other than the specified part can damage your unit and
will void your manufactures warranty.
Warning:
If after you have replaced the lamp or fuse and you continue to blow
either one, STOP using the unit. Contact customer support for further
instructions, you may have to return the unit for servicing. Continuing
to use the unit may cause serious damage.
Fuse Replacement:
Disconnect the unitʼs main power supply. Insert a standard flat head
screw driver in to the fuse holder housing (located on the rear of the
unit). Turn the screwdriver in a counter-clockwise direction to remove
the fuse holder. Remove the old fuse and discard it, replace the fuse
with the same type. Insert the fuse holder back into itʼs housing and
turn in clockwise direction to lock the holder in place.
Lamp Replacement:
Caution! Never open the unit when in use. Always disconnect the
main power and allow the fixture ample time to cool before attempt-
ing to replace the lamp. Lamp replacement has been made simple by
incorporating a split dome that is retained by thumb screws.
Again,
please remember to always replace with the exact same type lamp.
1. Be sure to follow the proper procedures when handling halogen
bulbs.
2. Lamp replacement has been made simple by incorporating the use
of trap door type hinge top cover and thumb screws.
3. Loosen the two thumb screws on top cover.
4. Flip the top cover in an upright position.
5. Remove and replace the lamps.
6. Reassemble.
