©
American DJ Supply
®
- www.americandj.com - Spiral Scan™ Instruction Manual Page 11
Lamp Replacement:
Caution! Never open the unit when in use.
Always disconnect the main power and allow the unit ample time to
cool before attempting to replace the lamp. Remember always replace
with the same type lamp and fuse.
1. Be sure to follow the proper procedures when handling discharge
lamps.
2. Lamp replacement has been made simple by incorporating the
use of a removable cover and thumb screws.
3. Remove the two thumb screws on bottom of the unit that hold the
socket assembly in place.
4. Carefully pull out the socket assembly.
5. Remove and replace the bulb.
6. Reassemble.
This chart details the gobo pattern as well as the gobo wheel place-
ment. When used with a DMX controller gobo one may be used as
a spot or color changer. Gobos two through eight will rotate, rotation
will be controlled by DMX channel five. Gobos two through eight may
also be replaced with custom gobos. Please contact customer service
for custom gobos.
©
American DJ Supply
®
- www.americandj.com - Spiral Scan™ Instruction Manual Page 12
Spiral Scan™
Gobos
Spiral Scan™
Lamp Replacement
Focusing:
1. To focus a Spiral Scan,™ disconnect main power and flip the option
dip switch one to the on position. Then reconnect main power.
2. After the unit resets the lamp will strike. The mirror will center and
a preselected gobo will projected.
3. Loosen the thumb screw on the front of the unit that hold the lens
in place.
4. Adjust the focus by manually moving the lens up and down.
5. Tighten the thumb screw after you achieve your desired focus.
6. Disconnect main power and return the number one option dip
switch to the off position.
7. Reconnect main power.
Spiral Scan™
Focusing
Retaining thumb screws
Lamp Socket Assembly
1
