Operatinge Modes:
You can use the Sonic Beam II
TM
in three ways:
• Stand alone mode - The unit will react to sound, chasing
through the several built in programs. You can also use the
optional Sonic Beam II/C Remote Control to set blackout,
strobe or slow scan mode.
• Master/Slave mode - You can daisy chain up to 16 units
together to get a synchronized light show that will react to
sound chasing through several built in programs.
• DMX control mode - This function will allow you to control
each individual fixtures traits with a standard DMX 512
controller such as the American DJ Show Designer.
TM
Stand Alone Mode:
The Sonic Beam II
TM
has a sophisticated built-in light show that
will run to sound simply plug the fixture in and it will chase
through its programs via sound. You can also use the optional
Sonic Beam/C Remote Control to set blackout, strobe or slow
scan mode.
Master-Slave Operation:
1. This function will allow you to link up to 16 units together to
run on the master unit’s 2 channel internal programs.
2. In Master-Slave operation one unit will act as the controlling
unit and the others will react to the controlling units
programs. Any unit can act as a Master or as a Slave.
3. Daisy chain your units via the XLR connector on the bottom
of the units.
4. Use standard XLR microphone cables to link your units
together. Remember that the Male XLR connector is the
input and the Female XLR connector is the output. The first
unit in the chain (master) will use the female XLR connector
only. The last unit in the chain will use the male XLR
connector only.
5. To run the 2 channel show, turn every other fixtures dip switch
10 to the on position.
For example, if you have four units, two on the right and two
on the left, you might want to set the outside two units to
do one thing, and the middle two to do a variation on the
same theme. Set dip switch 10 ‘off’ to make the scan work
the same and ‘on’ to select the variation. Even if you only
have two units you will probably find that you get a better
light show if you set dip switch 10 ‘on’ on the second unit.
6. To run a synchronized light show set all the dip switch on all
the fixture to the ‘off’ position. All fixtures will now run in the
same exact pattern.
7. After all the settings have been set, power-up the fixture, they
will react to sound.
8. You can also use the optional Sonic Beam/C Remote
Control.
If you want to use the optional remote control, connect the
Sonic Beam/C
TM
controller to the first fixture in the line (master).
Note: The remote control only operates in stand-alone mode.
If the remote is connected in DMX mode it will not function.
If the unit does not recieve an active DMX signal, the unit will
automaticaaly react to sound in the MAster/Slave mode. During
Master/Slave mode the all dip switches will be ignored except
dip switch number 10.
Note: Dip switch number 10 will have no effect on the first unit
in the Master/Slave line. This is the unit that is generating the
light show.
DMX Mode:
Operating through a DMX controller give the user the freedom
to create his/her own programs tailored to their own individual
needs. This function also allows you to use your fixtures as spot
lights.
1. This function will allow you to control each individual fixture’s
traits with a standard DMX 512 controller such as the
American DJ
®
Show Designer™ or the American DJ
®
DMX
Operator.™
Sonic Beam II™ Operating Instructions
Sonic Beam II™ Operating Instructions
©
American DJ Supply
®
- www.americandj.com - Sonic Beam II™ Instruction Manual Page 8
©
American DJ Supply
®
- www.americandj.com - Sonic Beam II™ Instruction Manual Page 7
