Duty Cycle:
Because the Neutron Star™ can be used for continuous output (ie
while simulating lightning), it can build up intense heat. Due to this
intense heat built up the unit should not run for 15 minutes continu-
ously. After 15 minutes of continuously use allow the unit to cool for
about fifteen minutes, this will greatly increase the lamp life and
insure product longevity.
STAND ALONE MODE:
This mode allows you to operate your units without any type of
controller. The unit will function as a normal strobe light. Rate and
Intensity (brightness) are set directly on the unit. Note that these set-
tings are made using the adjustable knobs on the rear panel of the
unit. Once the settings are made they can only be changed by physi-
cally moving the switches on the unit. Be aware of this if you plan on
installing your strobe in a permanent application, if your are not satis-
fied with your settings you will have to physically remove them and
adjust the knobs. Experiment with the different values and setting to
achieve your desired flash.
OPTIONAL REMOTE:
American DJ
®
offers several remote controls that may be used to
control the unit by remote such as the S-10S controller. Some remote
controls will allow you to chase several strobes and some may allow
you to only adjust the flash rate. The remote operations very by
model, please see your dealer or visit our web site for more informa-
tion on the available remote controls.
©
American DJ
® -
www.americandj.com - Neutron Star™ Instruction Manual Page 5
Neutron Star™ Operating Instructions
Neutron Star™ Lamp Replacement
Caution:
Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ
®
techni-
cian. Replace with anything other than the specified part can damage
your unit and will void your manufactures warranty.
Warning:
If after you have replaced the lamp or fuse and you con-
tinue to blow either one, STOP using the unit. Contact customer sup-
port for further instructions, you may have to return the unit for ser-
vicing. Continuing to use the unit may cause serious damage.
Fuse Replacement:
Disconnect the unit’s main power supply.
Insert a standard flat head screw driver in to the fuse holder hous-
ing (located on the rear of the unit). Turn the screwdriver in a coun-
ter-clockwise direction to remove the fuse holder. Remove the old
fuse and discard it, replace the fuse with the same type. Insert the
fuse holder back into it’s housing and turn in a clockwise direction to
secure the holder in place.
Lamp Replacement:
Caution! Never open the unit when in use.
Always disconnect the main power and allow the fixture ample time
to cool before attempting to replace the lamp. Lamp replacement has
been made simple by incorporating a remove tray that is retained by
a single thumb screws. Again, please remember to always replace
with the exact same type lamp.
1. Be sure to follow the proper procedures when handling halogen
lamps. Never touch the new lamp with your bare fingers.
2. Unscrew the four Phillips screw located on the front panel of the
unit.
3. Remove the glass lamp cover to expose the lamps.
4. Remove and replace the lamp with an exact match.
5. Reassemble in reverse order.
Halogen Lamp Warning!
This fixture is fitted with
halogen lamps which are highly susceptible to dam-
age if improperly handled. Never touch the lamps
with your bare fingers as the oil from your hands will
shorten lamp life. Also, never move the fixture until
the lamps have had ample time to cool. Remember,
lamps are not covered under warranty conditions.
©
American DJ
® -
www.americandj.com - Neutron Star™ Instruction Manual Page 6
