ADJ Products, LLC - www.adj.com - Micro Image RGB Instruction Manual Page 9
ADJ Products, LLC - www.adj.com - Micro Image RGB Instruction Manual Page 10
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning
the internal and external lenses should be carried out periodically to
optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the out-
side casing.
2. Clean the external optics with a microfiber cloth every 20 days.
3. Always be sure to dry all parts completely before plugging the
unit back in.
Cleaning frequency depends on the environment in which the fixture
operates (I.e. smoke, fog residue, dust, dew). In heavy use we recom-
mend cleaning on a monthly basis. Periodic cleaning will ensure lon-
gevity, and crisp beam output.
Micro Image RGB
Cleaning
Micro Image RGB
Trouble Shooting
Trouble Shooting: Listed below are a few common problems that
you may encounter, with solutions.
No laser output from the unit;
1. Be sure you have connected your unit into a standard wall
outlet.
2. Be sure that the unit is not in blackout mode.
3. In cold temperature situations it might take the laser a little longer
to produce output. It can take up to 3-5 minutes for the laser to
produce a beam. This is due to the laser diode which is very sen-
sitive.
Unit does not respond to sound;
1. Low frequencies (bass) should cause the unit to react to sound.
Tapping on the microphone, quiet or high pitched sounds may
not activate the unit.
Micro Image RGB
Laser Remote Reset
Erase Remote Code:
Using a small utensil, carefully press and hold the Remote Code
button (5) for at least 7 seconds.
Activating and Linking Remote:
This action will set the code to
link the laser to your remote. You can link more then one laser to a
remote.
Using a small untensil, carefully press and hold the Remote Code
button (5) for at least 3 seconds. Try to control the unit with the
remote. If the unit can be controlled, setting the code was successful.
If it does not control the unit, try agin.
Micro Image RGB Operation
1. Press the Auto/Sound button. When the red indicator light
located on the front of the unit turns off, but flashes to the
beat of the music, the unit is in sound active mode.
Auto Play Mode:
This is Auto Play mode.
1. Press the Auto/Sound button. When the red indicator light light
flashes rapidly, the unit is in fast auto mode. When the
indicator light flashes slowly, the unit is in slow auto mode.
2. Use the speed knob to control the speed of the mode.
Remote Control:
Use the included remote to control various func-
tions. Please see below for button control.
Note: This remote control code has been set for this laser, so that
the laser can be controlled out of the box. If this code happens to get
erased the remote will not work with the unit. Please see below to reset
the code and link the laser to the remote again.
A Button -
Use this button to switch between Auto Play and Sound
Active. When the red indicator light light flashes rapidly, the unit is in
fast auto mode. When the indicator light flashes slowly, the unit is in
slow auto mode.
When the red indicator light located on the front of the unit turns off,
but flashes to the beat of the music, the unit is in sound active mode.
B Button -
Use this button to Blackout the unit.
C Button -
Use this button to scroll and select patterns.
D Button -
Use this button to select a show.
