Inno Scan LED
Cleaning
Inno Scan LED
Trouble Shooting
Trouble Shooting: Listed below are a few common problems that
you may encounter, with solutions.
No light output from the unit;
1. Be sure the external fuse has not blown. The fuse is located on
the bottom panel of the unit.
2. Be sure the fuse holder is completely and properly seated.
Unit does not respond to sound;
1. Low frequencies (bass) should cause the unit to react to sound.
Tapping on the microphone, quiet or high pitched sounds may
not activate the unit.
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning
the internal and external optical lenses and mirror should be carried
out periodically to optimize light output. Cleaning frequency depends
on the environment in which the fixture operates (I.e. smoke, fog
residue, dust, dew). In heavy club use we recommend cleaning on a
monthly basis. Periodic cleaning will ensure longevity, and crisp out-
put.
1. Use normal glass cleaner and a soft cloth to wipe down the out-
side casing.
2. Use a brush to wipe down the cooling vents and fan grill.
3. Clean the external optics with glass cleaner and a soft cloth every
20 days.
4. Clean the internal optics with glass cleaner and a soft cloth every
30-60 days.
5. Always be sure to dry all parts completely before plugging the unit
back in.
Inno Scan LED
Fuse Replacement
Locate and remove the unit’s power cord. Once the cord has been
removed located the fuse holder located inside the power socket.
Insert a flat-head screw driver into the power socket and gently pry
out the fuse holder. Remove the bad fuse and replace with a new one.
The fuse holder has a built-in socket for a spare fuse be sure not to
confuse the spare fuse with active fuse.
American DJ
®
- www.americandj.com - Inno Scan LED Instruction Manual Page 21
American DJ
®
- www.americandj.com - Inno Scan LED Instruction Manual Page 22
This unit comes with interchangable gobos. When changing
the gobos please be very careful. Follow the instructions below,
and see the figure pictures on the next page.
Caution!
Never open the unit when in use. Always disconnect
the main power before attempting to change the gobos.
1. Start by standing the fixture upright so that it is sitting on the
bottom handles. Unscrew the two phillips screws located on
the front panel just underneath the air vents.
2. Carefully remove the front panel to access the gobo wheel.
3. Rotate the gobo wheel with your hand until you find the gobo
you would like to change.
4. Using a pair of needle nose pliers, grab the retainer ring that
holds the gobo in place and remove the ring. You can also
remove the gobo by carefully pushing the gobo from the bot-
tom, pushing it up and out. Do this carefully so that you don’t
lose the retainer ring and the gobo.
5. Once you have removed the gobo carefully insert your new
gobo and reinsert the retainer ring.
6. Reassemble the unit.
Inno Scan LED
Gobo Replacement
