©
American DJ Supply
®
- www.americandj.com - Fusion Scan 250™ User Manual Page 5
Fusion Scan 250™
Laser Warninig Labels
©
American DJ Supply
®
- www.americandj.com - Fusion Scan 250™ User Manual Page 6
Fusion Scan 250™
Set Up
Power Supply:
Before plugging your unit in, be sure the source volt-
age in your area matches the required voltage for your American DJ
®
Fusion Scan 250.™ The American DJ
®
Fusion Scan 250
™
is available
in a 120v and 220v version. Because line voltage may vary from venue
to venue, you should be sure your unit voltage matches the wall outlet
voltage before attempting to operate you fixture. Also be sure the power
cable matches the voltage and current requirements of the unit.
DMX-512:
DMX is short for Digital Multiplex. This is a universal pro-
tocol used by most lighting and controller manufactures as a form of
communication between intelligent fixtures and controllers.
A DMX
controller sends DMX data instructions from the controller to the fix-
ture. DMX data is sent as serial data that travels from fixture to fixture
via the DATA “IN” and DATA “OUT” XLR terminals located on all DMX
fixtures (most controllers only have a DATA “OUT” terminal).
DMX Linking:
DMX is a language allowing all makes and models of
different manufactures to be linked together and operate from a single
controller, as long as all fixtures and the controller are DMX compli
-
ant.
To ensure proper DMX data transmission, when using several
DMX fixtures try to use the shortest cable path possible. The order
in which fixtures are connected in a DMX line does not influence the
DMX addressing. For example; a fixture assigned a DMX address of
1 may be placed anywhere in a DMX line, at the beginning, at the
end, or anywhere in the middle. Therefore, the first fixture controlled
by the controller could be the last fixture in the chain. When a fixture
is assigned a DMX address of 1, the DMX controller knows to send
DATA assigned to address 1 to that unit, no matter where it is located
in the DMX chain.
Data Cable (DMX Cable) Requirements (For DMX and Master/Slave
Operation):
The Fusion Scan 250™ can be con-
trolled via DMX-512 protocol. The Fusion Scan
250™ is a five channel DMX unit. The DMX address
is set using the dipswitches on the front panel of
the unit. Your unit and your DMX controller require
a standard 3-pin XLR connector for data input and
data output (Figure 1). If you are making your own
cables, be sure to use standard two
Figure 1
